|
| |
Lighting Instructions:
- Extend fold-up legs.
- Set Quikfire on solid
level ground in an area clear of overhead or side hazards or flammable
material (i.e. overhanging branches, brush, tents, etc.).
- Using the hand wheel
thread the regulator fitting into an approved propane tank.
- Light a match or lighter
and place over the first hole in pipe on the hose end.
- Turn the valve on the
fuel source to open, and then slowly turn the red valve 2 1/8 turn open. The
match will ignite a flame from the first hole. Adjust red valve until flame
in first hole is 2 inches high.
- CAUTION: If match or
lighter goes out before Quikfire ignites, turn red valve to off and wait
several minutes for propane to clear before lighting another match.
- Once first hole is
burning continue around the outside edge of Quikfire, lighting the rest of the
holes.
- CAUTION: Never turn red
valve more than 2 1/8 turns before lighting. DO NOT turn gas flow on and
light by throwing a match at Quikfire – THIS MAY CAUSE AN EXPLOSION!
- Once all holes are lit
remove your hand and then turn the red valve up to the desired fire level.
- After you have finished
enjoying your Quikfire turn the valve on the propane tank off, then turn the
red valve to off.
- Let cool at least twenty
minutes before handling or packing the Quikfire.
INSTRUCTIONS IF QUIKFIRE
IS TURNED OVER WHILE LIT:
1.
If Quikfire is turned over while lit DO NOT TOUCH QUIKFIRE!
2.
Immediately TURN OFF RED VALVE or valve on propane tank.
3.
REMEMBER – QUIKFIRE IS HOT! Either wait for unit to cool down or use
gloves before turning unit right side up.
|
